This lever is a lower cost replacement for the original adjustable clutch lever, but still matches the front brake lever. It fits the original clamp and sits in the same position as the adjustable lever did set at position 1 (furthest from handlebar) for maximum clutch pull. There is no adjuster on this lever.
If you have a 644 or 604 from 2001 on and need just the blade part of the lever assembly, you can detach your broken or bent blade where it fits the other section of the lever, by removing the circlip and pin.  This is a lower cost way of replacing your lever and keeping the adjuster providing your fitting between the lever and clamp is not damaged.
Replacement adjustable clutch lever.  This item fits all 644 models and 604 models 2001 onwards.

Replacement pair of levers to fit all models of 404DS and Rotax models up to 2001 before the adjustable clutch lever was fitted as standard.
Replacement non genuine clutch lever blade to suit all GasGas Randonne, Fantic 250E Casa 4T & CCM 404 models and Rotax models up to 2001.  Please note, this does not come with the rubber grip on the lever blade.
Replacement decompressor lever to suit Rotax models with the decompressor kit already fitted.

Replacement front brake lever blade.
Replacement choke lever.  This is actually a Yamaha part but is the same fitment.
Complete L/H lever and clamp assembly. 

Replacement alloy clutch lever/cable adjuster.
Replacement clutch lever clamp to suit 404 and early 604 models with the choke lever mounted half way down the handlebar.
Replacement L/H lever clamp incorporating mirror boss.

Replacement front brake lever/mirror clamp for all models.
Genuine Brembo front brake master cylinder repair kit for models using the 11mm bore size.
Replacement lower handlebar clamp for Rotax models using the Paioli front forks.

Replacement Brembo front brake lever shroud.
Replacement front brake lever adjuster.
Replacement upper handlebar clamp for Rotax models using the Paioli front forks.

Replacement set of WP handlebar clamps.

Replacement lower handlebar clamp for WP forks.

Replacement WP upper handlebar clamp.


Replacement WP M8x30 top clamp bolt.
If your CCM has Renthal Fat Bars, the L/H part of handlebar where grip slides onto is knurled to help the grip stick. This may need filing slightly to help decompression lever slide over it. Alternatively order Decompressor kit B to have a lever with a split clamp.
If your CCM has Renthal Fat Bars, the L/H part of handlebar where the grip slides onto is knurled to help the grip stick. This lever has a split clamp so that there is no need to remove the left grip to fit the lever. This type of lever uses a internal screw to clamp the inner cable, so you will need to cut the cable nipple off to length and thread it into the lever. Kit A is more simple here as it has a fixed length cable with a nipple each end and does not need to be cut.

This riser kit will raise the bars by 25mm.